A shoutout should be made to my lovely assistant who recommended using an angle to the other rafter for ease of installation. Once the anchor was in place, I seated the first steel pole into it to get the distance for the second anchor. ProMountings commercial grade pull-up bars specifically designed to fit easily to I-Beams ranging in width from 3.5 inches to 10+ inches. Additionally, after the initial seating, I went back and added several alternating pattern deep length deck screws to support the lag bolts and to improve overall stability of the ceiling anchor. Also, the pictures don't show this, but I feel I should mention, each of the lag bolts was seated with a washer so that it would really hold the flange and the 2x4 onto the rafter. TDS Joist Mount Chin Up Bar Chinning Bar 1 1/4 Dia x 47 long heavy wall tube 30 Degree down angle at ends Can be mounted on any Wood Joist Great for. Luckily, I had my socket driver, and with a little elbow grease, i got them to seat nicely. ![]() ![]() I had to muscle the hex lag bolts the last of the way because my adorable little 19V powerdrill did not have the Oomph necessary to finish the job. Get special offers, deals, discounts & fast delivery options on. ![]() Word of warning (because I goofed a bit here) my drill bit was a bit short and did not fully drive deeply enough into the rafter. Shop Joist Mount Pull Up Bar by Ultimate Body Press online at a best price in Bangladesh. (I knew I wasn't going to get another shot at it and I didn't want to wreck my ceiling). After finding the ceiling rafters with the stud finder, I predrilled the holes into them and made sure that each predrilled hole would line up.
0 Comments
Leave a Reply. |